|Circuit:||Single Circuit||Cooling Capacity:||18KW~3000KW|
|Heat Exchange Tube:||Copper Tube||Color:||Customized|
Single Circuit Shell Tube Heat Exchanger,
3000KW Shell Tube Heat Exchanger,
1000KW Shell And Tube Heat Exchanger
Chiller Corrosion Resistant
Shell and Tube Heat Exchanger Oil Cooler
Oil Cooler Features (Introduction):
1, water-cooled oil cooler using water as a medium and oil for heat exchange, the advantage is better
cooling effect, to meet the relatively low oil temperature requirements (the oil temperature can be reduced
to about 40 ℃, the disadvantage is that there must be in the water Of the place to use.
2, air-cooled oil cooler using air as a medium and oil for heat exchange, the advantage is to air as a
cooling source, basically not limited to the use of places, and environmental protection, the disadvantage
is due to the impact of ambient temperature, the higher the temperature , The oil temperature can not be
reduced to the desired temperature (air cooling is generally difficult to reduce the oil temperature only
higher than the ambient temperature of 5 ~ 10 ℃).
Hydraulic systems and lubrication systems are an important part of each mechanical device. The hydraulic
system needs to maintain high pressure at work and produce a lot of heat, and the oil temperature rises
after a long period of time.
If there is no timely discharge of heat, will lead to the system of sealing components aging, damage, and
the viscosity of the oil with the oil temperature rise and low, the oil pressure is also less than the
requirements of the work.
To ensure safe and reliable operation of the unit. The oil temperature must be controlled within the
specified range. Lubrication system oil temperature rise Although the main reason and the hydraulic
system is different, but also need to control the oil temperature within the specified range.
CONDENSER SERIES SINGLE SYSTEM
CAPACITY: 110RT TO 200RT
|Model||Refrig. ton (RT)||Refrig. ton (104kcal/h)||Dimension (mm)||Weight (kg)||Max. water flow|
P (fluoride inlet)
Copper pipe diameter (inch)
Copper pipe diameter (inch)
|W (standard port)||W (optional port)|
|FPT(inner pipe thread)||Male flange||Male flange|
WATER TO WATER HEAT EXCHANGER
CAPACITY: 100KW TO 400KW
|Model||Capacity (KW)||Dimension (mm)||Weight (kg)|
|Specification||Connection type||Specification||Connection type|
|QXWW8S6||G1-1/2||internal pipe thread||G1-1/2||internal pipe thread|
|QXWW15S6||G1-1/2||internal pipe thread||G1-1/2||internal pipe thread|
|QXWW20S8||G2||internal pipe thread||G2||internal pipe thread|
|QXWW30S8||G2-1/2||internal pipe thread||G2-1/2||internal pipe thread|
Pressure design: Normally the shell design pressure is 1.0MPa, tube design pressure is 1.5MPa, heat pump type tube design pressure is 2.4MPa. For other special requirements, please contact the technical department.
Contact Person: Mrs. Nichole Deng